Content of the material
- Just Wait it Out
- Dishwashing soap
- 7. Use an Enzyme Product
- How to unclog a toiletwith vinegar and baking soda
- About Author
- David Brown
- Try a Vacuum
- How Does It Work?
- Why It Works…
- How do you unclog a toilet when plunger fails?
- Epsom salt
- 5. Use a Wire Coat Hanger When Nothing Works
- DIY a Drain Snake Using a Wire Hanger
- 2. Combination of Baking Soda and Vinegar
- Why does my poop hurt so big?
- Dish Soap
- How to unblock a toilet with water pressure
- Use a Plastic Bottle to Create Water Pressure
- Best Bleaches to unclog the toilet
- Clorox Bleach
- Kaboom Scrub Free Bleach
- Lysol No Mess Automatic Bleach
- Scrubbing Bubbles Toilet Bleach
- Green Works Toilet Bleach
- Steps to Unclog Toilet with Bleach Hot Water
- What you will need
- Method #1. Using Bleach Only
- Method #2 Bleach and Hot Water to Unclog Toilet
- No Worst Case Scenarios With The Best Toilet Hacks
- QUICK SERVICE ON EMERGENCY CALLS – 24/7
Just Wait it Out
Sometimes, all you need to do is wait. This method requires nothing but patience (and perhaps a second bathroom). The water in your toilet exerts pressure on the clog in the drain as it attempts to leave. Over time, the pressure could dislodge the clog on its own. Be prepared to wait for as long as overnight, though. Additionally, you should be ready to stop the flow of water if you attempt to flush the toilet the next day and the clog is still there.
Byrne suggests pouring some dishwashing soap into the toilet to get the clog loosened up. You’ll need to pour about half a cup into a half-filled toilet and allow it to sit for 10 to 20 minutes before trying to flush again. “The idea here is to have the soap coat the pipes and allow for easier passing of the clog,” says Byrne.
7. Use an Enzyme Product
Enzyme waste removal product also works great when used to unclog a toilet. Buy an enzyme product that can liquefy waste material effectively. You can get this product from most grocery and home improvement stores that focus on the plumbing line.
This enzyme waste removal is mostly used in a septic system to disintegrate waste. The best part is that it doesn’t harm your pipes and your health as well. However, except for organic waste, it will not work on toilet clogged by toys or other solid objects.
Here is a great tip on how to unclog a toilet with enzymes. First, read the guide on the product label to know the recommended amount to pour into the drain.
After you have read it carefully, pour the required amount of the enzyme as instructed into the bowl. Then wait for a few minutes to allow the enzymes to come into action. That way, it softens the clog, and allows the toilet to drain.
How to unclog a toiletwith vinegar and baking soda
To unblock a toilet with baking soda and vinegar, pour a cup of baking soda (fizzier) or bicarbonate of soda if that is what you have to hand, into the toilet bowl. Follow it with a cup of white vinegar. Allow this to fizz for 20 minutes. Flush; this should have cleared most blockages and left a fresher smell also.
David Brown is an efficient Master Plumber hailing from Glen, Maryland, United States. He is a famous name in the Plumbing industry with a golden career of 20 years. It all started when Jason pursued…Read More About This Author
Try a Vacuum
Yep, that’s right: a vacuum. Don’t bust out your standard floor vacuum, though, or you’ll risk getting electrocuted and damaging the equipment. Instead, grab a wet/dry vac from the garage and get to work.
How Does It Work?
Place a hose attachment you don’t intend to use again into the toilet drain. You now have two options: use the suck feature to try to pull out the clog or use the blow feature to try to push it down through the pipes. Both can work; the latter will just create a bit more splashing.
Why It Works…
Shop vacuums work on everything! But really, the suck feature can pull the clogged material out of the toilet. The blow feature can create enough air pressure in the drain to dislodge the stuck material.
How do you unclog a toilet when plunger fails?Cover the plunger in water.
You need water, not air, pressure to loosen the clog. If your toilet lacks water, pour in enough water till the plunger is covered. Use a gentle plunge initially since a hard one will force air back around the seal, blowing water all over you and your bathroom floor.
Don’t have any bath bombs on hand? According to Miller, epsom salt will work just as well to also create a fizzy reaction in the toilet bowl. Create a mixture using a handful of the bath salts and enough water to coat the salt, then pour it directly into the toilet.
5. Use a Wire Coat Hanger When Nothing Works
This is another inexpensive yet very effective method of unclogging a toilet.
Step 1: Use a Wire Coat Hanger
If you have a wire hanger lying around your house, grab it, loosen it, and straighten it up in readiness for this next method.
Step 2: Cover the End of the Wire with an Old Towel
If your toilet is porcelain, cover the wire with an old towel at one end to prevent it from scratching your toilet. Then to achieve a good seal around your wire hanger, wrap up the old towel with some duct tape.
Step 3: Insert the Wire Coat Hanger
Then insert the covered end of the wire hanger into your toilet, then push it into the drain while twisting it to get rid of any blockage so water can move freely down the drain.
Step 4: Keep on Pushing
Continue pushing even if you can’t feel any resistance coming in from the toilet. Just stop when the water starts to flow again.
Step 5: Flush It!
You can now flush the toilet to get rid of any residual blockage inside the bowl.
If the wire coat hanger isn’t working for you, try the next method below.
DIY a Drain Snake Using a Wire Hanger
A more severe blockage could require manually moving the item. To do this without a plunger, unravel a wire coat hanger until it’s straight. Push one end of the wire into the clogged area. Prod the debris until it becomes free and flows down the drain. Voila!
2. Combination of Baking Soda and Vinegar
If the plunger doesn’t work, a mixture of vinegar and baking soda is another ideal option. These substances are mostly present in the kitchen, but if it is not available, you can head to local store to get one. Once you have them, follow this procedure on how to unclog the flushing toilet with baking soda and vinegar.
First, pour 2 cups of water and a cup of soda into a container. Mix thoroughly, and then pour the mixture into the toilet bowl. Afterward, pour two cups of vinegar into the toilet and wait for several minutes or even hours.
You will notice bubbles from the bowl when you add vinegar due to the combination of the substances. The reaction going on between the baking soda and vinegar will help loosen the materials blocking the toilet, thus allowing the water to flow freely. With that said, it unclogs the toilet. But if this method does not work, try the next option.
Why does my poop hurt so big?Anal Fissures
It’s common to get small tears inside or around your anus, the opening where your poop comes out. These anal fissures are often caused by a large or very hard stool. They cause the muscles around your anus to spasm, so bowel movements hurt.
If just plain old hot water isn’t cutting it, you can try using hot water with the addition of dish soap. Dish soap is made to break down grease, dirt, and grime. Put about a cup or so of dish soap right into the toilet bowl. Add the hot water and let the mixture sit for a while.
In some cases, it can take about 30 minutes to work. Depending upon the clog, however, you might have to let it sit as long as overnight. If you don’t feel like running to the kitchen to grab the dish soap (or you’re running low and don’t want to run out), shampoo can be a very adequate substitute.
How to unblock a toilet with water pressure
If all of the above fail to work, you could try breaking up the blockage using water pressure. For this you will need a pressure washer and a pipe cleaning kit to connect to it. Insert the hose into the toilet bowl, switch on the pressure washer and you will see the hose will be pulled down the pipe until it reaches the blockage. If the blockage can be broken down, the water pressure will do this. Again, don’t do this if you have a toilet with a macerator – it might be that the toilet’s not blocked, just won’t flush because there’s something caught around the mechanism.
Use a Plastic Bottle to Create Water Pressure
Warning: This unclogging trick could get messy.
Start by removing as much water from the toilet bowl as possible; you can do this by repeatedly filling a small container with toilet water and pouring the water into a bucket. Next, fill a large plastic bottle with warm water.
Place your thumb over the top of the bottle and fit the top end of the bottle into the outlet at the bottom of the toilet. (You’ll want to wear rubber gloves for this step.) Remove your thumb and squeeze the bottle so the water inside shoots down the pipe. The added pressure could dislodge whatever was causing the clog.
Check out these 100 plumbing goofs and other scary stuff!
Best Bleaches to unclog the toilet
This bleach is known by many as a perfect deodorant and cleaning agent.
To use clorox, add between a half and three-quarter cup of Clorox bleach on the clogged toilet.
Later on, flush the toilet using hot water. This bleach is effective for soft clogs and aids in killing germs and leaving the toilet in a sanitary state.
There are Clorox tablets that you can also drop in the toilet tank then flush. It leaves the toilet with sparkling blue color and smelling fresh.
Kaboom Scrub Free Bleach
This is an effective detergent that requires no scrubbing. You only need to pop in a pouch and the bleach does its job. Most customers have praised the bleach since it is easy to use and takes less time to unclog toilets.
However, some customers have complained about the smell it leaves behind.
Lysol No Mess Automatic Bleach
You can also employ this bleach. Just clip one of them onto the rim of the toilet, especially sections with heavy water flow, then leave it to unclog the toilet.
It offers a fresh ocean scent. Most customers have praised the product considering the ease of use, cheap price and the fresh smell it leaves behind.
Scrubbing Bubbles Toilet Bleach
This bleach clings onto your toilet and attacks the grime before flushing it away. It is contained in discs that also clean your toilet with every flush. Using the dispenser, stamp the disc on the toilet bowl then let it work.
The bleach prevents sticking around of all grime and repels lime that tends to build up in toilets.
Customers have praised the product due to its ease of use and the fresh scent it leaves upon every flush.
Green Works Toilet Bleach
This is also a cleaner made from Clorox. The chemical composition is gentle to the environment but is tough on toilet clogs such as mineral deposits and hard water stains.
It is made from plant and mineral-based components that are safe. To employ this bleach, squirt it and allow it to settle for 10 minutes. Later on, flush the toilet.
It has been praised since it is natural and smells great. Some customers have applauded the lemon candy aroma it leaves behind.
Steps to Unclog Toilet with Bleach Hot Water
What you will need
- Approximately 2 gallons of hot water
- 1-2 cups of liquid bleach
- A pair of Rubber gloves
Method #1. Using Bleach Only
- Put on your protective gear. Wear rubber gloves and goggles to protect your hands from buns and goggles to prevent water splashes that may end up in your eyes.
- Open the window, door, or turn on the fan to create ventilation. Unpleasant fumes may build up in the house, thus it is necessary to take caution.
- Pour 1 to 2 cups of bleach into the toilet. The amount will in most cases depend on the amount of water in the bowl; more water more bleach.
- For bleach work on the clog, allow it to sit for 5-10 minutes
- Turn on the water valve and flush the toilet.
Method #2 Bleach and Hot Water to Unclog Toilet
- Wear your protective gear and ensure the room is well ventilated
- Add the two cups of bleach into the bowl and allow them to work for around 10minutes.
- After the 10 minutes, add hot water such that it fills the toilet bowl halfway. Let the mixture rest for 5-7 more minutes.
- Flush the toilet twice or thrice to get rid and ensure it is clog-free.
No Worst Case Scenarios With The Best Toilet Hacks
Unclogging the toilet on your own is a filthy task, but it is manageable. If you skip the plumber and methods I recommended, you’ll save a lot of money. Some methods aren’t that gross, such as pouring enzyme cleaner or using baking soda and vinegar.
Don’t be afraid to mix methods, to try to solve the problem. Let me know if you have more questions about toilet unclogging hacks!
Keep me posted on how these hacks worked for you!
Please consider sharing the article with your friends and family!
- How to Treat Calcium Buildup in Toilet Pipes | DIY Plumbing Repairs. Plumber in Kingman, AZ | Plumbing By Jake. https://www.plumbingbyjake.com/blog/how-do-you-treat-calcium-buildup-in-toilet-pipes/.
- 18 Types of Toilets, Styles and Toilet Mechanisms [Full Guide]. My Plumber. https://my-plumber.co.uk/blog/types-of-toilets/.
- How to Keep Your Toilet Drain Clean – Cardinal Heating & Air Conditioning. Cardinal Heating & Air Conditioning. https://www.cardinalhvac.com/press-releases/how-to-keep-your-toilet-drain-clean/.
QUICK SERVICE ON EMERGENCY CALLS – 24/7
We have a project manager on call 24/7/365, ready to dispatch our plumbing experts. That means we’ve always got you covered in case of emergency. Call us first, and you won’t need to make a second call!TELL US WHAT YOU NEED